gmirror FAILURE - device detached (bylo gmirror Flags: DIRTY)

[Tibor Gres]

v mojom pripade:
atacontrol detach ata3-master
a nasledne:
atacontrol attach ata3-master

gmirror potom zacal rebuildovat od nuly.

> Tibor Gres wrote:
> [...]
>> disk si samozrejme mozes za behu znovu prihodit atacontrol prikazom,
>> nemusis kvoli tomu rebootovat - ale to je aj tak len barla (workaround)
>> a
>> je vhodne ten disk a kabel skontrolovat.
>
> A jak konkretne bych ho mohl znovu prihodit? Zkusil jsem
> atacontrol reinit ata4, ale nezabralo (disk by mel byt ad8 na ata4):
>
> # atacontrol attach ata4
> atacontrol: ioctl(IOCATAATTACH): File exists
>
> # atacontrol reinit ata4
> Master:      no device present
> Slave:       no device present
>
> # atacontrol list
> ATA channel 0:
>      Master:      no device present
>      Slave:  acd0 <ASUS DVD-E616A2/1.02> ATA/ATAPI revision 7
> ATA channel 1:
>      Master:      no device present
>      Slave:       no device present
> ATA channel 2:
>      Master:  ad4 <ST3250820AS/3.AAC> Serial ATA v1.0
>      Slave:       no device present
> ATA channel 3:
>      Master:      no device present
>      Slave:       no device present
> ATA channel 4:
>      Master:      no device present
>      Slave:       no device present
> ATA channel 5:
>      Master:      no device present
>      Slave:       no device present
>
> Miroslav Lachman
> --
> FreeBSD mailing list (users-l at freebsd.cz)
> http://www.freebsd.cz/listserv/listinfo/users-l
>